[Aug-2024] Updated Cisco 350-801 Dumps – PDF & Online Engine
350-801.pdf - Questions Answers PDF Sample Questions Reliable
NEW QUESTION # 33
An engineer is designing a load balancing solution for two Cisco Unified Border routers. The first router (cube1.abc.com) takes 60% of the calls and the second router (cute2.abc.com) takes 40% of the calls, Assume all DNS A records have been created.
Which two SRV records are needed for a load balanced solution? (Choose two.)
- A. sip_udp.abc.com 60 IN SRV 1 60 5060 cube1.abc.com
- B. sip_udp.abc.com 60 IN SRV 2 60 5060 cube1.abc.com
- C. sip_udp.abc.com 60 IN SRV 1 40 5060 cube2.abc.com
- D. sip_udp.abc.com 60 IN SRV 3 60 5060 cube2.abc.com
- E. sip_udp.abc.com 60 IN SRV 60 1 5060 cube1.abc.com
Answer: A,C
NEW QUESTION # 34
An engineer must configure a route pattern that can route all +E.164 globalized international numbers for the plans of all countries. Which Cisco UCM configuration accomplish this task?
- A.
- B.
- C.
- D.
Answer: D
NEW QUESTION # 35
A user reports that when receiving an inbound call on their IP Phone from the PSTN they are unable to transfer this call to another PSTN number. What is the reason for this failures?
- A. The incoming calling search space of the SIP trunk does not include the partition of the line in the IP phone.
- B. The gateway is configured with the wrong device pool.
- C. The IP phone is configured with the wrong region.
- D. The service parameter related to Offnet to Offnet Call Transfer is set to TRUE.
Answer: B
Explanation:
Section: Cisco IOS XE Gateway and Media Resources
NEW QUESTION # 36
An engineer is asked to implement on-net/off-net call classification in Cisco UCM Which two components are required to implement this configuration? (Choose two)
- A. SIP trunk
- B. SIP route patterns
- C. CTI route point
- D. route pattern
- E. route group
Answer: A,D
NEW QUESTION # 37
Refer to the exhibit.
A call is failing to establish between two SIP Devices. The Called device answer with this SDP. Which SDP parameter causes this issue?
- A. The calling device did not offer a ptime value.
- B. The RTP port is set to 0.
- C. The payload for G.711ulaw must be 18.
- D. The media stream is set to sendonly.
Answer: B
NEW QUESTION # 38
Endpoint A is attempting to call endpoint B.
Endpoint A only supports G.711ulaw with a packetization rate of 20 ms, and endpoint B supports packetization rate of 30 ms for G.711ulaw. Which two media are resources are allocated to normalize packetization rates through transrating?
- A. Hardware MTP on Cisco IOS Software
- B. Software MTP on Cisco Unified Communication Manager
- C. Software MTP on Cisco IOS Software
- D. Hardware transcoder on Cisco IOS Software
- E. Software transcoder on Cisco unified Communications manager
Answer: A,B
NEW QUESTION # 39 
Refer to the exhibit A user takes a phone from San Francisco to New York for a short reassignment. The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern in a route list that contains the Standard Local Route Group. To where does the call retreat?
- A. The call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco
- B. The call fails because device mobility is turned on. and the phone is not configured in New York The engineer must configure which sites the device should be roaming to
- C. The call fails because the Standard Local Route Group is being used only if no configuration is set for the device pools
- D. The call egresses in New York because the device automatically is assigned a New York device pool and uses the local gateway
Answer: A
NEW QUESTION # 40
Which action is required for a firewall configuration on a Mobile and Remote Access through Cisco Expressway deployment?
- A. The external firewall must allow these inbound connections to Expressway: SIP: TCP 5061; HTTPS: TCP 8443: XMPP: TCP 5222; Media: UDP 36002 to 59999.
- B. The internal firewall must allow these inbound and outbound connections between Expressway-C and Expressway-E. SIP: HTTPS (tunnelled overSSH between C and E): TCP 2222; TCP 7001; Traversal Media: UDP 2776 to 2777 (or 36000 to 36011 for large VM/appliance): XMPP: TCP 7400.
- C. The traversal zone on Expressway-C points to Expressway-E through the peer address field on the traversal zone, which specifies the Expressway-E server address. For dual NIC deployments, set the Expressway-E address using an FQDN that resolves the IP address of the internal interface
- D. Do not use a shared address for Expressway-E and Expressway-C, as the firewall cannot distinguish between them If static NAT for IP addressing on Expressway-E is used, ensure that any NAT operation on Expressway-C does not resolve the same traffic IP address Shared NAT is not supported.
Answer: D
NEW QUESTION # 41
An administrator is integrating a Cisco Unity Express module to a Cisco UCME system A test call is placed to the Cisco Unity Express pilot number, but the administrator receives a busy signal.
The dial- peer is configured as follows:
How is this issue resolved?
- A. The dial-peer needs to be reconfigured to support vad.
- B. The destination pattern needs to be changed to match the dialed number of 4100.
- C. The dial-peer needs to be reconfigured to support the G.711 voice codec.
- D. The dial-peer needs to be reconfigured to support H 323 instead of SIP.
Answer: C
Explanation:
"A voice activity detection (VAD) must be switched off and a codec must be designated."
https://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unity-express/62609- tdcmecue.html#anc17
NEW QUESTION # 42
Refer to the exhibit.
An engineer verifies the configured of an MGCP gateway. The commands are already configured. Which command is necessary to enable MGCP?
- A. Device (config) # com-manager active
- B. Device (config)# mgcp
- C. Device(config)# mgcp enable
- D. Device(config)# ccm-manager enable
Answer: B
NEW QUESTION # 43
Refer to the exhibit.
Refer to the exhibit. Given this "debug isdn q921" output, what is the problem with the PRI?
- A. Layer 1 is down on the controller.
- B. Nothing, the PRI is sending keepalives.
- C. Layer 2 is down on the controller.
- D. PRI does not have an IP address configured on the interface.
Answer: C
NEW QUESTION # 44
As a voice engineer, which two recommendations do you make to your company to optimize Cisco Unified Communications Manager configuration to reduce the number of toll fraud incidents? (Choose two.)
- A. Classify all route patterns as on-net or off-net and prohibit off-net call transfers in Cisco Unified CM Service parameters.
- B. Classify all route patterns as on-net and prohibit on-net to on-net call transfers in Cisco Unified CM service parameters.
- C. Classify all route pattern as off-net and prohibit off-net to off-net call transfers in Cisco Unified CM service parameters.
- D. Inbound CSS on any gateway typically should have access to internal destinations and PSTN destinations.
- E. Inbounds CSS on any gateway typically should have access to internal destinations only and not PSTN destinations.
Answer: C,E
NEW QUESTION # 45
User A Calls user. The call gets connected, but the quality is bed. What are two reasons for this issue? (Choose two)
- A. Incompatible codec
- B. Network congestion
- C. No region relationship
- D. Incorrect partition
- E. Incorrect QoS
Answer: B,E
NEW QUESTION # 46
Refer to the exhibit.
Refer to the exhibit. Given this "debug isdn q921" output, what is the problem with the PRI?
- A. Layer 1 is down on the controller.
- B. Nothing, the PRI is sending keepalives.
- C. Layer 2 is down on the controller.
- D. PRI does not have an IP address configured on the interface.
Answer: C
NEW QUESTION # 47
An engineer builds the configuration on a Cisco IOS gateway for the dial-peers:
Which command is required to complete the configuration?
- A. Codec g723ar63
- B. Codec g726r32
- C. Codec g729cr81
- D. Codec g711ulaw
Answer: D
NEW QUESTION # 48
Which command is used in Cisco IOS XE TDM gateway to configure the voice T1/E1 controller to provide clocking?
- A. clock source line
- B. clock source internal
- C. Cisco IOS XE TDM gateway T1/E1 controller cannot provide clocking.
- D. clock source network
Answer: B
Explanation:
Section: Cisco IOS XE Gateway and Media Resources
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/NIM/software/configuration/ guide/4gen-t1-e1-nim-guide.html
NEW QUESTION # 49
An incoming off-net call to a user fails. An engineer notices that the off-net call is G.711, but the phone accepts only G.729. which media resource on a Cisco Unified Border Element and Cisco Unified Communications Manager must the engineer configure to Manage the engineer configure to manage the codec negotiation?
- A. MOH
- B. CFB
- C. transcoder
- D. MTP
Answer: C
NEW QUESTION # 50
......
Cisco 350-801 Dumps PDF Are going to be The Best Score: https://pass4sure.passtorrent.com/350-801-latest-torrent.html