[Aug 30, 2022] NS0-183 Exam Brain Dumps - Study Notes and Theory
Pass Network Appliance NS0-183 Test Practice Test Questions Exam Dumps
NetApp NS0-183 Exam Topics:
| Section | Objectives |
|---|---|
| ONTAP Switches | - Identify the functions of supported switches - Demonstrate knowledge of how to configure/verify configuration requirements |
| Basic Installation Topics and Tools | - Describe installation preparation steps - Describe basic equipment installation steps |
| ONTAP Networking | - Describe the cluster network, e.g., multi-node, single node clusters - Demonstrate knowledge of the purpose of the management network - Identify the networking components in a cluster environment |
| ONTAP Concepts | - Identify general cluster terms used during installation - Identify ONTAP licensing for 9.7 |
NEW QUESTION 13
You install a new 2-node FAS8200 switchless cluster. You want to reach all necessary management LIFs and SPs for this cluster.
How many management IP addresses do you need in this scenario?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION 14
Click the Exhibit button.
You are installing a 2-node AFF A400 switchless cluster. You have cabled the management network to the e0M port. NetApp also recommends cabling to a redundant management network switch.
Referring to the exhibit, to which port should the redundant management network be cabled?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 15
After you deploy a 4-node AFF A220, you want to upgrade the ONTAP version of the cluster.
In this scenario, before the upgrade, which advanced CLI command is used to locate epsilon?
- A. cluster show
- B. cluster ha show
- C. clustering ring show
- D. cluster image show
Answer: A
NEW QUESTION 16
Click the Exhibit button.
A customer has a 2-node FAS8200 cluster with four DS212C shelves with 10 TB SATA drives.
Referring to the exhibit, an aggregate will be created with which default RAID type?
- A. RAID_TEC
- B. RAID1
- C. RAID4
- D. RAID_DP
Answer: A
NEW QUESTION 17
You are performing an automated upgrade of a 2-node cluster. Node-01 upgrades successfully. But during the node-02 upgrade, there is a power outage at the site. When power is restored and the nodes are booted, you receive this message: Warning: The Cluster is in a mixed version state. Update all of the nodes to the same version as soon as possible.
In this scenario, which command provides information that will help you understand the problem?
- A. system node upgrade show-task-status
- B. system node image package show
- C. system node upgrade-revert show
- D. system node image show
Answer: C
NEW QUESTION 18
Which keyboard combination enables you to access the Service Processor (SP) or the Board Management Control (BMC) from the system console CLI?
- A. Ctrl + S
- B. Ctrl + G
- C. Ctrl + D
- D. Ctrl + C
Answer: B
NEW QUESTION 19
You want to verify that connections are cables correctly and that shelf IDs are unique within an HA pair.
Which tool would be used to accomplish these tasks?
- A. Cloud Insights
- B. System Diagnostics
- C. Active IQ Unified Manager
- D. Active IQ Config Advisor
Answer: B
NEW QUESTION 20
You completed an ONTAP cluster deployment as a reseller engineer. During the knowledge transfer process to the customer, they ask for proof that the array has correct multi-path HA cabling deployed and that the array is error free.
Which documentation output would you present to the customer to satisfy this requirement?
- A. Active IQ OneCollect output
- B. NetAppDocs output
- C. Config Advisor output
- D. Active IQ Unified Manager output
Answer: C
Explanation:
Explanation/Reference: https://docs.netapp.com/platstor/topic/com.netapp.doc.hw-controller-add/GUID-64A51339-
1F03-451C-B062-9F97E772817E.html
NEW QUESTION 21
You are installing a new ONTAP 9.7 cluster and attaching the cluster to two separate networks. Your customer has indicated that the same range of client IP addresses are used on both networks and that the networks are never allowed to communicate with each other.
In this scenario, which ONTAP feature must be configured to securely allow all clients to access ONTAP NAS protocols?
- A. IPspaces
- B. broadcast domains
- C. routing
- D. BGP
Answer: A
Explanation:
https://www.netapp.com/media/16885-tr-4182.pdf 9.3 Multiple IPspaces with Overlapping IP Addresses
NEW QUESTION 22
You are planning to update your running switch environment. You must know that certain conditions exist before the FASTPATH software and the RCF on a NetApp CN1610 cluster switch can be installed.
Which condition must exist in this scenario?
- A. You can only update your switch environment within offline windows.
- B. All ISL ports must be moved to a different switch.
- C. All cluster logical interfaces (LIFs) must be up and must not have been migrated.
- D. You must set the port configuration to default for all ports before running the portcfgdefaultport-numbercommand.
Answer: C
NEW QUESTION 23
In ONTAP 9.7 software, how many different replicated databases (RDBs) exist per node?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
Explanation:
Explanation/Reference: https://www.storagefreak.net/2017/08/netapp-cdot-ontap-9-rdb-and-cluster-replication-ring
NEW QUESTION 24
Click the Exhibit button.
You have an 8-node cluster, and sometimes the data LIFs fail over to a non-working port.
Referring to the exhibit, what must you do to solve this problem?
- A. Configure more than one IPspace.
- B. Configure the LIFs using separate home nodes.
- C. Configure the MTU consistently across the cluster.
- D. Configure the correct Ethernet ports in all broadcast domains.
Answer: C
NEW QUESTION 25
You have just finished installing and configuring an ONTAP cluster for a customer.
In this scenario, which product collects information and produces site documentation?
- A. NetAppDocs
- B. Active IQ OneCollect
- C. SnapGathers
- D. Inventory Collect Tool
Answer: A
NEW QUESTION 26
Click the Exhibit button.
You are reviewing the setup of a recently installed FAS9000 switched cluster. As shown in the exhibit, the cluster interconnects are connected to a pair of Cisco Nexus 3132Q-V 40 Gb ports.
For a high availability, which ports should swap Ethernet cables?
- A. Swap node1:e4a and node1:e8a.
- B. Swap node2:e4a and node2:e8a.
- C. Swap node1:e8a and node2:e4a.
- D. Swap node1:e4a and node2:e4b.
Answer: C
NEW QUESTION 27
You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are unable to discover the ONTAP controllers.
Which statement explains this behavior?
- A. You do not have network discovery enabled.
- B. You do not have a static IP address.
- C. You do not have IPv6 configuration set.
- D. You do not have a default gateway set.
Answer: A
Explanation:
https://docs.netapp.com/platstor/index.jsp?topic=%2Fcom.netapp.doc.hw-a800-install-setup%2FGUID-91C7E4FC-5B24-414C-ABF3-F2AAD1E465B1.html network discovery is not enabled on your laptop
NEW QUESTION 28
Click the Exhibit button.
You want to add a FAS2750 HA pair to an existing 6-node cluster.
Referring to the exhibit, which action would you perform to begin adding the node?
- A. Use the exit or quit commands then run the cluster setup command.
- B. Reboot the node and enter maintenance mode and run the Cluster Setup wizard.
- C. Use the back command to begin the Cluster Setup wizard.
- D. Use the node setup wizard and select 0a as the management interface.
Answer: D
NEW QUESTION 29
You install a new FAS2650 HA with a DS224C disk shelf and ONTAP 9.5 on a customer site.
Referring to the exhibit, which steps are required to get an HA cabled system?
- A. 1. Insert a cable from right controller port 0a to IOMA port 1, and from port 0b to IOMB port 3. 2. Insert a cable from left controller port 0a to IOMB port 1, and from port 0b to IOMA port 3.
- B. 1. Insert a cable from right controller port 0a to IOMB port 2, and from port 0b to IOMA port 3. 2. Insert a cable from left controller port 0a to IOMA port 2, and from port 0b to IOMB port 3.
- C. 1. Insert a cable from right controller port 0a to IOMB port 1, and from port 0b to IOMA port 4. 2. Insert a cable from left controller port 0a to IOMA port 1, and from port 0b to IOMB port 4. 3. Cable the out-of-band ACP.
- D. 1. Insert a cable from right controller port 0a to IOMB port 2, and from port 0b to IOMA port 4. 2. Insert a cable from left controller port 0a to IOMA port 2, and from port 0b to IOMB port 4. 3. Cable the out-of-band ACP.
Answer: A
NEW QUESTION 30
You install a 4-node cluster with an AFF A400 HA pair and a FAS8300 HA pair. After setup, you are asked to review the audit logs on each controller from a Web browser.
In this scenario, which method provides access to the logs from a Web browser?
- A. DNS
- B. ACP
- C. ADP
- D. SPI
Answer: D
Explanation:
https://docs.netapp.com/ontap-9/index.jsp?topic=%2Fcom.netapp.doc.dot-cm-sag%2FGUID-E593FD00-D062-4649-853A-4409E282FA12.html
NEW QUESTION 31
A customer wants to expand a 10-node AFF A700s NAS cluster running with Cisco Nexus 3132Q-V cluster interconnect switches using new nodes.
In this scenario, what is the maximum number of nodes to be added into this cluster?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 32
You have just finished installing and configuring an ONTAP cluster for a customer.
In this scenario, which product collects information and produces site documentation?
- A. NetAppDocs
- B. Active IQ OneCollect
- C. SnapGathers
- D. Inventory Collect Tool
Answer: A
Explanation:
Explanation/Reference: http://197.253.9.244/ontap%209-5/Cluster%20Admin/2_Student%20Guide/STRSW-ILT- ONTAPADM_StudentGuide.pdf
NEW QUESTION 33
You are planning to install a new ONTAP 9.7 All SAN Array (ASA) into your existing data center.
In this scenario, which cluster configuration is allowed with ASA controllers?
- A. Add the ASA controllers to an existing 4-node cluster with NAS licenses.
- B. ASA controllers can only be installed as a standalone HA pair.
- C. Add the ASA controllers to an existing 10-node cluster.
- D. ASA controllers can only be added to clusters that have existing SAN licenses.
Answer: D
NEW QUESTION 34
......
Verified NS0-183 dumps Q&As - NS0-183 dumps with Correct Answers: https://pass4sure.passtorrent.com/NS0-183-latest-torrent.html